Contiki-NG
|
Header with configuration defines common to all CC13xx/CC26xx platforms. More...
Go to the source code of this file.
Macros | |
Network Stack Configuration | |
#define | CC2650_FAST_RADIO_STARTUP (MAC_CONF_WITH_TSCH) |
#define | PROP_MODE_CONF_RX_BUF_CNT 4 |
#define | NETSTACK_CONF_RADIO ieee_mode_driver |
#define | CSMA_CONF_SEND_SOFT_ACK 0 |
#define | NETSTACK_RADIO_MAX_PAYLOAD_LEN 125 |
IEEE address configuration | |
Used to generate our link-local & IPv6 address | |
#define | IEEE_ADDR_CONF_HARDCODED 0 |
Location of the IEEE address 0 => Read from InfoPage, 1 => Use a hardcoded address, configured by IEEE_ADDR_CONF_ADDRESS. | |
#define | IEEE_ADDR_CONF_ADDRESS { 0x00, 0x12, 0x4B, 0x00, 0x89, 0xAB, 0xCD, 0xEF } |
The hardcoded IEEE address to be used when IEEE_ADDR_CONF_HARDCODED is defined as 1. | |
RF configuration | |
#define | IEEE_MODE_CONF_AUTOACK 1 |
RF H/W generates ACKs. | |
#define | IEEE_MODE_CONF_PROMISCOUS 0 |
1 to enable promiscous mode | |
#define | RF_BLE_CONF_ENABLED 0 |
0 to disable BLE support | |
Character I/O Configuration | |
#define | CC26XX_UART_CONF_ENABLE 1 |
Enable/Disable UART I/O. | |
#define | CC26XX_UART_CONF_BAUD_RATE 115200 |
Default UART0 baud rate. | |
#define | BOARD_CONF_DEBUGGER_DEVPACK 1 |
JTAG interface configuration | |
Enable/Disable the JTAG DAP and TAP interfaces on the chip. Setting this to 0 will disable access to the debug interface to secure deployed images. | |
#define | CCXXWARE_CONF_JTAG_INTERFACE_ENABLE 1 |
ROM Bootloader configuration | |
Enable/Disable the ROM bootloader in your image, if the board supports it. Look in board.h to choose the DIO and corresponding level that will cause the chip to enter bootloader mode. | |
#define | CCXXWARE_CONF_ROM_BOOTLOADER_ENABLE 1 |
Header with configuration defines common to all CC13xx/CC26xx platforms.
Definition in file cc13xx-cc26xx-conf.h.