6tisch/etsi-plugtest-2017
The 1st F-Interop 6TiSCH Interoperability Event
Overview
This project was used to build firmwares for the 1st F-Interop 6TiSCH Interoperability Event, which worked well in all the tests except for “secjoin”.
Supported Hardwares
The following hardwares were used in the event:
Zolertia Remote (TARGET=
zoul, BOARD=remote)JN156x (TARGET=
jn516)CC2650 LaunchPad (TARGET=
cc26x0-cc13x0, BOARD=launchpad/cc2650)
Usage
Access to your target board through serial connection. You’ll get available
commands by hit help on the shell prompt.
> help
Available commands:
'> help': Shows this help
'> ip-addr': Shows all IPv6 addresses
'> ip-nbr': Shows all IPv6 neighbors
'> log module level': Sets log level (0--4) for a given module (or "all"). For module "mac", level 4 also enables per-slot logg'> ping addr': Pings the IPv6 address 'addr'
'> rpl-set-root 0/1 [prefix]': Sets node as root (on) or not (off). A /64 prefix can be optionally specified.
'> rpl-status': Shows a summary of the current RPL state
'> rpl-global-repair': Triggers a RPL global repair
'> rpl-local-repair': Triggers a RPL local repair
'> routes': Shows the route entries
'> tsch-schedule': Shows the current TSCH schedule
'> tsch-status': Shows a summary of the current TSCH state
'> reboot': Reboot the board by watchdog_reboot()
'> 6top help': Shows 6top command usage
Your board runs as a 6TiSCH node by default. Its role can be changed to DAG root
by rpl-set-root 1.
You can see how it works with test-with-cooja-mote.csc.
Configuration
Edit project-conf.h if necessary.
UIP_CONF_IPV6_CHECKS: set 0 if you want to disable checksum validationSIXP_CONF_WITH_PAYLOAD_TERMINATION_IE: set 1 if you want to append Paload Termination IE in 6P frames