slip-arch.c

Go to the documentation of this file.

/*
 * Copyright (c) 2018, Texas Instruments Incorporated - http://www.ti.com/
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 * 3. Neither the name of the copyright holder nor the names of its
 *    contributors may be used to endorse or promote products derived
 *    from this software without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
 * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
 * FOR A PARTICULAR PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE
 * COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
 * (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
 * SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
 * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
 * OF THE POSSIBILITY OF SUCH DAMAGE.
 */
/**
 * \addtogroup cc13xx-cc26xx-cpu
 * @{
 *
 * \defgroup cc13xx-cc26xx-slip-arch SLIP for CC13xx/CC26xx.
 * @{
 *
 * \file
 *        Implementation of SLIP driver for CC13xx/CC26xx.
 * \author
 *        Edvard Pettersen <e.pettersen@ti.com>
 */
/*---------------------------------------------------------------------------*/
#include "contiki.h"
#include "dev/slip.h"
/*---------------------------------------------------------------------------*/
#include "uart0-arch.h"
/*---------------------------------------------------------------------------*/
/**
 * \brief    Write a single byte over SLIP.
 * \param c  The byte to write.
 */
void
slip_arch_writeb(unsigned char c)
{
  uart0_write(&c, 1);
}
/*---------------------------------------------------------------------------*/
/**
 * \brief  Initialize the SLIP driver.
 */
void
slip_arch_init(void)
{
  /*
   * Set an input handler. In doing so, the driver will make sure that UART
   * RX stays operational during deep sleep.
   */
  uart0_init();
  uart0_set_callback(slip_input_byte);
}
/*---------------------------------------------------------------------------*/
/**
 * @}
 * @}
 */